Еднокомпонентен Хидроизолиращ Агент на Полиуретанова Основа TECMA IMPERAL P 2008

Surfaces must be dry and free of grease, oil, sand, dust or any other contaminant. Smooth and non-porous surfaces must be mechanically cleaned to obtain good adhesion. When recovering from old waterproofing agents, wash the surface to remove any residual contamination. Then allow the surfaces to dry.

Before applying the product, always apply a primer such as IMPRIMACION E-EPOXIDICA or TECMA PAINT A-H, especially on surfaces with moisture, thus allowing better adhesion to the surface and its compaction, which will prevent the formation of bubbles. On very porous surfaces, apply a second coat of primer until you have a complete seal.

• Mix the contents in the container with a low-speed mechanical mixer until a homogeneous mixture is obtained.
• Let the mixture rest for a few minutes to remove the air. The product can be diluted if necessary with TECMASOL C to 10% to assist in layering the product.
• Then apply coatings, each 1 kg/m thick.²by spreading the product evenly with a 2 mm notched trowel, rubber harrow or short-haired solution-resistant roller. Roller application is suitable for spreading the product but not for painting the surface. The product should not be applied as a paint but as a self-leveling product.
• After ten minutes, it is important to use a needle roller to remove any air that may still be inside. When applying 3 coats, each should be 0.660 kg/m thick.².

Application to asphalt sheets or acrylic waterproofing materials shall be made directly once the surface has been properly cleaned and prepared.

Paved waterproofing: Allow the product to dry completely after application. Place a separate coating, then our GEOTEXTIL, fine and dry sand coating and then the mortar to secure the flooring.

• Do not dilute with any solvent other than the recommended one
• Do not apply directly when the substrate is condensed
• Do not apply to hot substrates or at high temperatures
• In very hot weather and with very low relative humidity, the drying time will be longer
• The product cures with ambient humidity. Once the container is opened, the entire product should be used to prevent it from curing

The product is supplied in 10 kg. metal containers. The tightly closed containers can be stored for a period of 6 months in a dry place and with temperatures below +30⁰С.

Our information and recommendations should be interpreted without legal obligation. It is the customer's responsibility to verify the suitability of the products for their intended purposes.

• Can be applied to new terraces as well as old ones for restoration
• Much more water separation than most similar products on the market
• Higher perforation resistance at low and high temperatures
• Ability to age well in cold weather with temperatures between 0⁰C and +10⁰With the addition of ACELARANTE AF